Unibrain Fire-i Guía de instalación Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 19
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
Unibrain Fire-i digital camera Quick Installation Guide
8
i. Prepare
Check that your operating system is one of the supported (Windows 2000/XP/2003/Vista or XP
64 bit).
Important Remark for Windows XP: although the use of the latest Microsoft Service Pack is
usually recommended, please consider that the application of SP2 in Windows XP may reduce
your FireWire bandwidth to 100 Mbps if any 1394b adapter or 1394b device is connected.
Please consult us at support@unibrain.com
for alternative solutions.
Uninstall any previous versions of Fire-i™ software.
Get the FireiSetup.3.61.x64.exe (for 64-bit operating system) or the FireiSetup.3.61.x86.exe
(for 32-bit operating system) file from the \Windows folder of your CD, or download the latest
version from: http://www.unibrain.com/downloads/
.
Disconnect any camera from your FireWire adapter(s).
Installation of Microsoft DirectX 9.0b or higher is recommended but not required. You can get
DirectX by connecting to: http://www.microsoft.com/downloads/. Installation of DirectX can
happen before or after installation of Fire-i™.
ii. Install
Run the FireiSetup.3.61.x64.exe or the FireiSetup.3.61.x86.exe file.
This will fully install:
a. the Fire-i Application, including the collection of provided camera drivers,
b. the Fire-i Authorize Utility. Fire-i Authorize Utility is used for licensing (activating) the Fire-i
drivers for NON-Unibrain
cameras. All Unibrain cameras do not require a license.
The following figures describe the installation process.
In case there is a camera connected to your PC, you must disconnect it and then click OK.
In the next dialog, choose the “Typical” type of setup and press next. Click “Finish” on the last dialog and
the installation process will be completed.
iii. Camera driver manual installation
At first connection, your camera will be recognized by Microsoft Windows and will be installed in the
driver list as Generic 1394 Desktop Cameras. This basic driver does not allow full IIDC support.
So, you should open the Device Manager window, locate the new camera and update manually its driver
as depicted in the following figures.
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 18 19

Comentarios a estos manuales

Sin comentarios